Home > Knowledge > Content
curtain wall profiles cutting machine(4)
Apr 12, 2018

7. Use and operation

7.1 Adjustment Before Operation

7.1.1 Adjusting the Position of the Compression Cylinder

   The profile is placed on the workbench of the machine. The clamping cylinders of the two saw heads are adjusted to the most suitable position for pressing the workpiece, and then the cylinder is fixed and pressed.

7.1.2 Adjustment of Blade Feed Speed

   In the test machine process, if you feel that the feed speed of the saw blade is not suitable, you can adjust the speed input joint into the cylinder to increase or decrease the feed speed to obtain the required feed speed.

7.2 sawing angle adjustment (release the locking handle before adjusting the angle)

   The machine tool is adjusted according to the above items, and the test is performed after the test is performed for 10 minutes. If no abnormality occurs, the following adjustments can be made.

7.2.1 90° adjustment (blade extends perpendicular to the table)

Before the machine tool company has been commissioned and inspected, it can directly saw the profile and check whether the sawing surface of the 90° angle meets the requirements. The initial angle of the sawing machine is set to 90° and the error is ±10′. If it does not meet the requirements, the bolt on the limit stop can be adjusted and the sawing measurement can be repeated to meet the requirements. Then tighten the nut on it.

7.2.2 Adjustment of 45° angle (set to 45° when saw blade extends 45° from the table top angle, the same below)

  Loosen the locking handle on the workbench, click the angle selection switch to 45°, and the angle cylinder is ventilated. After the 45° angle is in place, lock the handle. Check whether the profile meets the requirements after sawing the profile (error is ±10'). If it does not meet the requirements, the limit screw on the limit stop can be adjusted to repeat the sawing and measurement to meet the requirements. Then tighten the nut on the screw and tighten the lock handle.

7.2.3 67.5°. Angle adjustment

Loosen the locking handle and click the angle selector switch to 67.5° to allow the indexing cylinder to vent and push the frame to 67.5°. Saw the profile; check whether its 67.5° angle meets the requirement (error is ±10′). If it does not meet the requirements, you can adjust the limit screw on the positioning rod, repeat the sawing, measure it to meet the requirements, then tighten the nut on the screw and tighten the handle.

7.3 Workpiece length adjustment

See the CNC system operation


Products List